Under Manual Code, click on Enter Code.

Tap I DO NOT HAVE A CODE OR CANNOT SCAN if the the code is not shipped with the device (or scan the code if you already have the code is shipped).

The App will start preparing your light for connection to your Wifi.

Repeat steps 3-6 above and select PAIR LIGHT (If you have the code on your packaging you can start directly on step 3 and select Pair Light).

Now that you have your HomeKit code, you are ready to connect your light.

Lights shipped with HomeKit codes in the packaging will have the code etched on the base of the bulb or the reverse side of the lights controller (Find the code here).

This code is needed to complete the setup. You can save this as an image to your camera roll.

You will receive your unique HomeKit Code.Press Light Settings, then tap PAIR in the HomeKit status section.Click on the three dots in the top right corner of the screen.Launch the LIFX app on your smartphone.Hold it down for 10-15 seconds, and then release (for LIFX Z and Beam).Turn your light off and on at the wall 5 times slowly at consistent intervals.Start by ressetting your light and router to ensure it will be detected on the network.Start with the LIFX light on.When these requirements are satisfied you can jump into the next phase and follow the steps below to connect the LIFX light with Apple HomeKit:

Create an account on Apple HomeKit, then you can set up your LIFX light.Download the Apple Home app and enable Siri.Make sure that you have the latest firmware on your LIFX lights (You can follow these instructions to update the firmware).Requirement: there are some requirements that you need to satisfy before pairing the light with Homekit. This chapter will guide you through the steps that you need to do in order to integrate your LIFX light with Apple HomeKit. How to delete the LIFX light from HomeKit?.

Download lifx z